Latest Updates on Laser Machines

This is oil lubrication pump,we need to pour machine oil into it.When the “LUB” green light is on, it is work time, range in 1-999 seconds. When the “INT”red light is on, it is a rest time, range in 1-999 minutes.If figures are 990,it means pump will spray oil every 990 minutes. Long press “SET” fo

Determine the cutting speed according to the cutting material and thickness. Appropriate cutting speed, can not only increase the cutting efficiency, but also improve cutting quality. Here is the influence of different cutting speed on cutting quality.The influence of larger feed speed on cutting qu

The step to adjust the toaxality between nozzle hole and laser beam is as follows:1) Paint inkpad (usually, the red is good) at the outlet end face of nozzle, bond the adhesive film at the outlet end face of nozzle. This is showed as the follow picture.

Maintenance of plasma cutting machine1. Assemble the torch correctlyInstall the cutting torch correctly and carefully, make sure that all parts are well matched, and ensure that the gas and cooling air flow. Install all the parts on a clean flannel to avoid dirt sticking to the parts. Add appropriat

a. Rotate the IHS Delay button to set pierce height.But now we don’t know the value,so we need to set a value randomly.And change it after we get the distance between the torch and the plate as below.The final distance should be 5mm. i. Press the torch will move down and torch the plate, then the t

How to do the maintenance of woodworking engraving machine

1. The spindle . A,air cooling spindle.If your spindle is air cooling ,you can do like this ,use Compressed air clean the Fan and the Air duct

AluminumCut speed too fast

a.Given voltage -The given voltage value determines the distance between the torch and the plate during cutting.i.Set given voltage value according to the cut chart.（if we don’t have cut chart,we can press”PREHEA” to let torch cut metal.At the same time,obeserve Actual Voltage,for example actual vol

How to generate nc file with Artcam 2011 Here is a simple example ,I will show you step by step. First open the software.