Automatic Edge Banding Machine with Pre-Milling and Corner Rounding

Automatic Edge Banding Machine with Pre-Milling and Corner Rounding

The EASTRISE CNC automatic edge banding machine applies and finishes edge banding on suitable straight-edged furniture panels. It combines eight processing stages in one production line: pre-milling, gluing and pressing, end cutting, rough trimming, fine trimming, corner rounding, scraping and buffing.

Designed for cabinet and panel furniture production, the machine supports workpiece thicknesses of 8–60 mm and edge banding thicknesses of 0.3–3 mm. Its feed speed of 18–24 m/min supports continuous panel processing.

Main Processing Functions

1. Pre-Milling
Machines the panel edge before gluing to help remove minor cutting marks and prepare a clean, even bonding surface.

2. Gluing and Pressing
Applies adhesive and presses the edge banding against the panel. Adhesive and banding material compatibility should be confirmed for the selected configuration.

3. End Cutting
Cuts excess edge banding at the leading and trailing ends of the panel.

4. Rough Trimming
Removes excess banding from the upper and lower edges before fine finishing.

5. Fine Trimming
Finishes the upper and lower edges to produce a consistent profile.

6. Corner Rounding
Uses profile-following cutters to finish the banded panel corners. The resulting profile depends on the tooling and settings.

7. Edge and Glue Scraping
Refines the trimmed edge and removes residual adhesive where the corresponding scraping units are fitted.

8. Buffing and Cleaning
Buffs the finished edge to improve its appearance and remove light processing residue.

Main Features

• Integrated processing from edge preparation to final buffing.

• Pre-milling for panel edge preparation before adhesive application.

• Separate rough and fine trimming stages.

• Profile-following corner rounding.

• Feed speed of 18–24 m/min.

• Suitable for panel thicknesses from 8 to 60 mm.

• Supports edge banding thicknesses from 0.3 to 3 mm.

Technical Specifications

Minimum workpiece dimensions may depend on the operation and panel proportions. Confirm the permitted length and width combinations before production. Final electrical requirements and configuration should be confirmed before ordering.

Typical Applications

This automatic edgebander is intended for straight-edge finishing of suitable panels used in:

• Kitchen cabinets and wardrobes

• Office furniture

• Shelving and storage units

• Panel furniture components

• MDF, particleboard and plywood furniture production, subject to material testing

Panel condition, adhesive selection, edge banding material and machine settings affect the finished result.

Frequently Asked Questions

What does an automatic edge banding machine do?
It applies edge banding to panel edges and trims and finishes the applied material. This model also includes pre-milling and corner rounding.

Does this machine include pre-milling?
Yes. The listed configuration includes two 1.8 kW pre-milling motors for preparing the panel edge before gluing.

Does it include corner rounding?
Yes. Profile-following corner rounding is included, with two 0.37 kW motors.

What panel thickness can it process?
The specified workpiece thickness range is 8–60 mm. Edge banding height and trimming settings must be matched to the panel.

What is the feed speed?
The specified feed speed is 18–24 m/min. Actual output depends on panel size, spacing, handling and processing requirements.

Can it process curved panel edges?
This machine is intended for straight-edge processing. Corner rounding finishes the corners of banded panels; it does not make the machine suitable for curved-edge banding.

What information is needed for a quotation?
Provide the panel material, panel dimensions, edge banding material and thickness, preferred adhesive, available voltage and required production capacity.

Request a Quotation

Contact EASTRISE CNC with your panel and edge banding requirements to confirm the machine configuration, electrical supply and quotation.