The Eastrise TM2480A-2 automatic vacuum membrane press machine is designed for decorative PVC film application on furniture components. Its applications include cabinet doors, shaped furniture panels and interior decorative surfaces.
Successful lamination depends on matching the substrate, adhesive, film and pressing cycle. Testing representative components before production helps establish suitable settings for each design.
Routed cabinet doors need a covering process that follows both the flat surface and decorative profiles. During vacuum forming, heated PVC film is drawn over the prepared component and bonded using a compatible adhesive.
This process can create a continuous decorative finish across the door face, routed contours and accessible outside edges.
Smooth sanding and thorough dust removal are essential before adhesive application. Surface defects left on the substrate may remain visible through the film.
Woodgrain PVC films offer a decorative option for wardrobe doors and furniture fronts. The printed finish should be selected to suit the panel design and the intended appearance.
When arranging components, check grain direction and keep it consistent across matching doors. Allow sufficient spacing between parts so the film can form around the profiles.
Film thickness, stretch behaviour and profile geometry should be checked together. Deep recesses, tight corners and complex shapes require sample trials before batch processing.
Shaped decorative panels can use compatible PVC films to create coordinated colours and textures for interior furniture projects.
Profiles should be designed with forming in mind. Rounded transitions and accessible contours help the film follow the surface, while sharp undercuts can make forming difficult.
Approve the most demanding profile in a sample trial before processing a complete order.
| Item | Specification |
|---|---|
| Model | TM2480A-2 |
| Brand | Eastrise |
| Working area | 2500 × 1300 mm |
| Maximum board thickness | 60 mm, including the bottom plate |
| Total installed power | 25 kW |
| Heating system | Aluminium plate and stainless steel heating tubes |
| Vacuum pump | Chinese-brand vacuum pump |
| Control system | PLC |
| Machine weight | 2500 kg |
| Power supply | 380 V, 50/60 Hz |
Final specifications and electrical requirements should be confirmed for the ordered configuration.
Prepare the substrate. Machine the required profile, sand the surfaces and remove dust.
Apply compatible adhesive. Follow the adhesive supplier’s instructions for coating and drying.
Arrange the components. Use suitable supports and leave space for film forming.
Position the PVC film. Check coverage, decorative direction and the sealing area.
Run a validated pressing cycle. Set heating and vacuum stages for the selected material combination.
Cool, trim and inspect. Check the face, grooves, corners and edge bonding.
Use the approved sample as the reference for production quality.
Inspect sample parts for wrinkles, bridging across recesses, visible surface defects and lifting at the edges. Check adhesion after the required cooling or curing period.
Keep records of the film, adhesive, substrate and process settings. If a material changes, repeat the sample trial before continuing production.
A visually smooth surface alone does not confirm adequate bonding. Include an appropriate adhesion check in the inspection process.
It is used to form and bond compatible decorative coverings onto prepared components, including suitable furniture doors and shaped panels.
These applications require confirmation of the membrane, adhesive, temperature range and machine configuration. They should be evaluated separately from PVC film lamination.
The name alone does not confirm that capability. Confirm the machine’s pressing arrangement and the required finishing process before ordering.
Provide component dimensions, maximum profile height, substrate details, film samples, adhesive information and expected production requirements.
Send Eastrise your panel drawings and covering material details to discuss a suitable configuration.
Confirm the working area, loading height, material compatibility and sample finish before placing an order.
Home About Us Products Applications Video Download FAQ News Contact Us