You are here: Home » News

Latest Updates on Laser Machines

  • With the increasing awareness of environmental protection and safety, there will be fewer and fewer chemicals that can be used for industrial cleaning. However, laser cleaning has the characteristics of non-contact, no thermal effect, no wear, and is suitable for all kinds of materials, which can so
  • Circle cutting demands precise motion control and circle cut quality will vary as the circle diameter approaches the thickness of the plate. In general, a circle that is equal in diameter to the thickness of the plate being cut is the minimum circle diameter possible. Cut quality will decrease marke
  • WHERE TO LOCATE YOUR PLASMA CUTTING MACHINE Before you unpack your machine, select the area where you will use your machine. There are no hard-and-fast rules for its location, but below are a few guidelines.1. There should be an area around the machine suitable for the length of job that you will
  • This is oil lubrication pump,we need to pour machine oil into it.When the “LUB” green light is on, it is work time, range in 1-999 seconds. When the “INT”red light is on, it is a rest time, range in 1-999 minutes.If figures are 990,it means pump will spray oil every 990 minutes. Long press “SET” fo
  • Determine the cutting speed according to the cutting material and thickness. Appropriate cutting speed, can not only increase the cutting efficiency, but also improve cutting quality. Here is the influence of different cutting speed on cutting quality.The influence of larger feed speed on cutting qu
  • The step to adjust the toaxality between nozzle hole and laser beam is as follows:1) Paint inkpad (usually, the red is good) at the outlet end face of nozzle, bond the adhesive film at the outlet end face of nozzle. This is showed as the follow picture.
  • Maintenance of plasma cutting machine1. Assemble the torch correctlyInstall the cutting torch correctly and carefully, make sure that all parts are well matched, and ensure that the gas and cooling air flow. Install all the parts on a clean flannel to avoid dirt sticking to the parts. Add appropriat
  • a. Rotate the IHS Delay button to set pierce height.But now we don’t know the value,so we need to set a value randomly.And change it after we get the distance between the torch and the plate as below.The final distance should be 5mm. i. Press the torch will move down and torch the plate, then the t
  • How to do the maintenance of woodworking engraving machine

ABOUT US

Jinan Eastrise Innovations Co.,Ltd.is an innovative enterprise engaged in research and development,production,sales and good after-sales service.

CONTACT US

Email:info@eastrisecnc.com / export01@eastrisecnc.com
Tel:+8653155557430

Whatsapp +8613306415461 /  +8615624033801
WeChat: +8618769810842  / +86 15624033801
Address:No.59 Huayuan Road,Licheng District, Jinan City,Shandong Province,China
Copyright © 2023 Jinan Eastrise Innovations Co.,Ltd. All rights reserved. Supported by Leadong